Μήνυμα για τους χρήστες φορητού αναγνώστη

Καλώς ορίσατε, Εάν χρησιμοποιείτε πρόγραμμα φορητού ανάγνωστη σας συνιστούμε να μεταβείτε σε "Λειτουργία πλήρους πρόσβασης".Αυτή η λειτουργία έχει σχεδιαστεί για να βοηθήσει διαφορετικους τύπους πλοήγησης:


Μετάβαση στο κύριο περιεχόμενο


Επιλογές Προσβασιμότητας

Μέγεθος γραμματοσειράς:

Πλάτος διάταξης:

twindisc1
twindisc2
twindisc3

Twin Disc offers a new line of pump drives to meet a broad range of hydraulic system set-ups and application needs. These drives are available in a wide variety of gear ratios, including both speed increasing and reducing configurations.

The modular design of these pump drives enables you to choose from several input options, including a rubber block drive, or clutch to match your SAE engine flywheel dimensions. Independent mounting is also an option, both direct and with a clutch.

For your pump mounting requirements, Twin Disc offers standard SAE adaptor kits as well as a wide variety of non-SAE adaptations for your special needs.

With models having one, two, three, four or six pump pads, Twin Disc is sure to have a pump drive to complement your hydraulic application.

    • Cast iron housings
    • Case hardened and ground spur gears, except AM 110, AM 220, AM 330, AM 216 and AM 320 where gears are shaved
    • Ball bearings
    • Case hardened shafts
    • Viton seals on input shaft
    • Output rotation opposite the direction of input rotation
    • Gear ratios identical on all outputs for each model, except AM 640 which may have different ratios on outputs
    • Modular design

powered by dynamicsite.gr